Riepilogo posizione PRIMARY PURPOSE: New product introduction, include device preparation, prototype setup, assembly line preparation, documentation preparation. Assembly line transfer RTM smooth & continuous process improvement New manufacturing technology introduction SPECIFIC RESPONSIBILIES: Required: Effectively cooperate with product designer to optimize product design and validation. Lead new assembly line build-up according to product requirement by lean thinking. Cooperation with quality engineer to deal with Quality Complain and Customer audit in project early stage. Operator training: orientation training and training for new employees. New manufacturing technology research and development. Be responsible for process documentation preparation and review, such as build report, process flowchart, process map, PFMEA, work instruction etc. Be responsible for sample build. Assembly line specific parts concept design, be responsible for new production line running smoothly and into ramp up stage in time. Responsible for productivity and capacity improvement, include manpower, line balance and assembly line layout optimization. Responsible for assembly line transfer, include device, technology, and documentation. Process capability analysis, continuous process improvement and optimization, such as, WIP reduction, product failure mode analysis, production yield improvement Responsabilità essenziali EDUCATION: Required: Bachelor’s degree in mechanical engineering Preferred: Master’s degree in mechanical design WORK RELATED EXPERIENCE: Required: 4+ years’ work experience as a process engineer Good assembly device debug skill Be familiar with mechanical design, assembly process. Preferred: 10+ years is better. Be familiar with molding, stamping, plating process. Be familiar with automatic control, laser, ultrasonic application. Be familiar with Robot technology, vision experience. OTHER TECHNICAL/PROFESSIONAL QUALIFICATION/SPECIFIC COMPETENCY: Required: Be familiar with IE tools, such as 5W1H, Poka Yoke, Motion analysis, Line balancing analysis, Combination work analysis, and Kaizen activities, like PDCA cycle, 7 steps, 5S, Standardized Work, ECRS, Process Mapping, etc. Familiar with office software (MS Office, AutoCAD) Basic knowledge in TS 16949 Preferred: Lean experience Familiar with 3D software Others: Strong leaning & innovation thinking Good skills of communication and conflict handling Open minded, and self-motivated Excellent oral and written communication skills including English and Italian. #J-18808-Ljbffr